1995 FORD F-350

Report Date:
August 01, 2006
Campaign Number:
06V286000
Component:
VEHICLE SPEED CONTROL

Summary:
ON CERTAIN TRUCKS EQUIPPED WITH SPEED CONTROL, GASOLINE OR NATURAL GAS ENGINES, THE SPEED CONTROL DEACTIVATION SWITCH MAY OVERHEAT.

Consequence Summary:
OVERHEATING COULD RESULT IN SMOKE OR BURN AND AN UNDERHOOD FIRE.

Corrective Summary:
DEALERS WILL INSTALL A FUSED WIRING HARNESS INTO THE SPEED CONTROL SYSTEM FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 7, 2006. OWNERS MAY CONTACT FORD AT 1-866-436-7332. (NOTE: ALSO SEE RECALLS 05V017 AND 05V388)

1995 FORD F-350

Report Date:
May 24, 2006
Campaign Number:
06E049000
Component:
EXTERIOR LIGHTING

Summary:
CERTAIN CK MOTORSPORTS COMBINATION HEADLIGHTS, CLEAR CORNER, BUMPER, AND SIDE MARKER LIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON THE PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Consequence Summary:
WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

Corrective Summary:
CK MOTORSPORT WILL NOTIFY OWNERS AND REPLACE THE NONCOMPLIANT LAMPS FREE OF CHARGE. THE RECALL BEGAN ON JULY 1, 2006. OWNERS MAY CONTACT CK MOTORSPORT AT 1-909-610-7211.

1995 FORD F-350

Report Date:
April 16, 1996
Campaign Number:
96V064000
Component:
SEATS

Summary:
THE WIRE HARNESS FOR THE POWER LUMBAR FEATURE ON THE SEAT IS UNDERNEATH THE FRONT SEAT CUSHION SUPPORT WIRES. THE SUPPORT WIRES ON THE DRIVER SEAT CAN CONTACT AND DAMAGE THE INSULATION HARNESS RESULTING IN A HIGH RESISTANCE ELECTRICAL SHORT THROUGH THE SUPPORT WIRES.

Consequence Summary:
CONSEQUENCE OF DEFECT: OVER HEATING OF THE SUPPORT WIRES COULD RESULT, AND MELTING, SMOKE, OR POSSIBLE IGNTION OF THE SURROUNDING MATERIALS COULD OCCUR.

Corrective Summary:
DEALERS WILL INSPECT THE SEATS ON THE AFFECTED VEHICLES. IF NO DAMAGE IS FOUND, THE DRIVER SEAT WIRE HARNESS WILL BE COVERED WITH A PROTECTIVE CONVOLUTE TUBING, WRAPPED WITH ELECTRICAL TAPE AND THE HARNESS WILL BE REROUTED. IF DAMAGE IS FOUND, THE WIRE HARNESS WILL BE REPLACED.